CZ P-07 & CZ P-09 red dot mounts

CZ P-07 & CZ P-09 red dot mounts replace the rear sight with a model-specific dovetail plate so you can add an optic to non-Optics Ready slides—no milling and fully reversible.

Why mount on CZ P-07 / CZ P-09?

• Keep the slide original: add a dot without permanent machining or refinish work.
• Prove the setup first: test optic models and positions, then swap back to irons in minutes.
• Carry/range friendly: compact mounts and dots help preserve balance and holster fit.

Footprints commonly supported

• Trijicon RMR footprint
• Shield RMSc footprint
• Holosun K-series footprint
• Leupold DPP footprint
• C-More RTS footprint
• Vortex Venom / Docter footprint
• Aimpoint ACRO footprint

Install checklist

• Degrease interfaces and screws; apply Loctite threadlocker.
• Torque to spec for mount-to-slide and optic-to-mount screws; re-check after your first range session.
• Verify screw length & pitch so nothing protrudes into the slide channel.

Model notes

If your slide is Optics Ready, a plate gives a lower, more rigid interface—see Optics Ready plates. The P-09 Nocturne and other direct-fit CZs accept RMSc / Holosun K-series dots without a plate.