CZ P-09 red dot mounts

CZ P-07, CZ P-09 red dot mount universal | type C Outer Impact

CZ P-09 red dot mounts

(2 products)

CZ P-09 red dot mounts swap into the rear-sight dovetail so you can add an optic to a non-Optics Ready P-09—no slide milling and fully reversible.

Why mount on the P-09?

  • Keep the slide uncut: upgrade to a dot without machining or refinish work.
  • Prove it first: test optic models/positions at the range, then switch back to irons in minutes.
  • Duty/range friendly: low-profile mounts help preserve balance and holster fit.

Footprints commonly supported

  • Trijicon RMR footprint
  • Shield RMSc footprint
  • Holosun K-series footprint
  • Leupold DPP footprint
  • C-More RTS footprint
  • Vortex Venom / Docter footprint
  • Aimpoint ACRO footprint

Install checklist

  • Degrease interfaces and screws; apply Loctite threadlocker.
  • Torque to spec for mount-to-slide and optic-to-mount screws; re-check after your first range session.
  • Verify screw length & pitch so nothing protrudes into the slide channel.

Model notes

If your P-09 is Optics Ready, use an OR plate for a lower, more rigid interface—see Optics Ready plates. The P-09 Nocturne direct-fit pattern accepts Shield RMSc / Holosun K-series optics without a plate.