CZ P-07 red dot mounts

CZ P-07 red dot mounts swap into the rear-sight dovetail so you can add a red dot to a non-Optics Ready P-07—no slide milling and fully reversible.

Why mount on the P-07?

• Keep the slide original: upgrade to a dot without machining or refinish work.
• Prove the setup first: test optic models/positions, then swap back to irons in minutes.
• Carry-aware: compact mounts and optics help preserve balance and holster fit.

Footprints commonly supported

• Trijicon RMR footprint
• Shield RMSc footprint
• Holosun K-series footprint
• Leupold DPP footprint
• C-More RTS footprint
• Vortex Venom / Docter footprint
• Aimpoint ACRO footprint

Install checklist

• Degrease interfaces and screws; apply Loctite threadlocker.
• Torque to spec for mount-to-slide and optic-to-mount screws; re-check after your first range session.
• Verify screw length & pitch so nothing protrudes into the slide channel.

Model notes

If you also run an Optics Ready CZ, a plate gives a lower, more rigid interface—see Optics Ready plates. Direct-fit CZs like Shadow 2 Carry and P-09 Nocturne accept RMSc / Holosun K-series dots without a plate.