CZ P-10S OR plates

CZ P-10S Optics Ready (OR) plates adapt the factory OR slide to a specific red-dot footprint and keep the optic low, rigid, and zeroed.

Which footprint do you need?

• Trijicon RMR footprint
• Shield RMSc footprint
• Holosun K-series footprint
• Leupold DPP footprint
• C-More RTS footprint
• Vortex Venom footprint
• Aimpoint ACRO footprint

Quick setup checklist

• Confirm your slide is the CZ P-10S Optics Ready variant.
• Select the plate that matches your optic’s footprint (see list above).
• Apply Loctite threadlocker to clean, degreased screws.

Installation basics

• Degrease interfaces and screws; use threadlocker.
• Torque to spec for plate-to-slide and optic-to-plate hardware.
• Verify screw length and thread pitch; witness-mark and recheck after the first range session.

Not “Optics Ready”?

Your CZ can still run a red dot without milling by using a dovetail red dot mount that replaces the rear sight.